User’s Guide – Ultima cutting plotter
60 AP-75032, Rev 2.2, 20/04/07
4.2.10. Factory Default
Settings of the active user can be reset to factory default.
Notes
Reset the factory default does not affect the Offset values and machine settings (EPOS connection, serial
number, ..)
To set the user to the Factory Default, please follow the instructions mentioned below :
Step 1 : In the general setting select ‘Factory Default’ by using the [UP] or [DOWN] key.
Step 2 : Press the [ENTER] key to confirm your selection. The display will show the following message.
Factory default
Actual : NO
New : NO
Reset settings
Step 3 : By using the [UP] or [DOWN] key select ‘YES’’.
Step 4 : Press the [ENTER] key to confirm. The settings of the Ultima cutting plotter will be resetted.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
To Next Page
Loading...
