User’s Guide – Ultima cutting plotter
59 AP-75032, Rev 2.2, 20/04/07
4.2.9. Cut Quality
You can choose a level of quality in the menu.
¾ Draft
¾ Normal
¾ High
Notes
This value has effect only on the ‘acceleration’ value.
The lower the acceleration → the higher the quality but the lower the throughput.
The higher the acceleration → the higher the throughput but the lower the quality.
To change the Cut Quality, please follow the instructions mentioned below :
Step 1 : In the general setting select ‘Cut Quality’ by using the [UP] or [DOWN] key.
Step 2 : Press the [ENTER] key to confirm your selection. The actual cut quality value will now be shown
on the display
Cut quality
Actual : DRAFT
New : DRAFT
Choose quality
Step 3 : By using the [UP] or [DOWN] key select an appropriate value.
Step 4 : Press the [ENTER] key to confirm.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
To Next Page
Loading...
