MUTOH Ultima - Clean Sensor and E-Pos Laser; Testing E-Pos Laser

User’s Guide – Ultima cutting plotter
88 AP-75032, Rev 2.2, 20/04/07
6.3. CLEAN SENSOR AND E-POS LASER.
Ultima’s sensors and E-pos laser will work better and last longer if you keep them clean and perform a few
simple daily maintenance tasks.
Use a cotton swab to clean the media sensors and E-pos laser.
6.3.1. Testing E-pos Laser
Please follow the instructions below to check if the Laser of the E-pos system is still working.
Step 1 : Press the [ORIGIN] key.
Step 2 : The LED should start lighting.
Step 3 : Press the [CANCEL] key to exit the setting.
Notes
Please do not look straight into the light.
Notes
In case the laser of the E-pos system is not working, please contact your local Mutoh dealer.