MUTOH Ultima - Test Selection; Presets Selection

User’s Guide – Ultima cutting plotter
38 AP-75032, Rev 2.2, 20/04/07
3.2.6. Test selection
In order to enable the user to check if the cutter is fully functional, without needing a computer, MUTOH has
integrated demo test cuts into the Ultima cutters.
For more information about the test cuts, please refer to the chapter ‘Fine-tuning your cutter to obtain Mutoh
quality’.
3.2.7. Presets selection
Using the presets makes it possible to store settings (all settings that can be changed from the panel) for
specific cutting jobs.
In the presets menu following options are available.
¾ Select Preset : Use this function to select a previously saved user setting.
¾ Reset : Change a saved user setting to a default value based on Mutoh’s values.
¾ Add : Add a new user setting.
¾ Remove : Remove a previously saved user setting.
3.2.7.1. ‘Select Presets’
Use this function to select a previously saved user setting. Please follow the instructions mentioned below.
Step 1 : Press the [PRESETS] key.
Step 2 : Following message will appear on the display.
Presets
Select presets
Choose user
Step 3 : Press the [ENTER] key. Following message will appear on the display.
→ User 1
Enter = select
↑ = Up
↓ = Down
Step 4 : Use the [UP] or [DOWN] key to select a user setting.
Step 5 : Press the [ENTER] key to confirm the selected user setting. The Ultima cutting plotter will load
the requested user settings.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.