MUTOH Ultima - Page 39

User’s Guide – Ultima cutting plotter
39 AP-75032, Rev 2.2, 20/04/07
3.2.7.2. ‘Reset’
Use this function to change a saved user setting to a default value based on Mutoh’s values. Please follow
the instructions mentioned below.
Step 1 : Press the [PRESETS] key.
Step 2 : Use the [UP] or [DOWN] key to select the following display.
Presets
Reset
Choose user
Step 3 : Press the [ENTER] key. Following message will appear on the display.
→ Monomeric vinyl
Enter = select
↑ = Up
↓ = Down
Step 4 : Use the [UP] or [DOWN] key to select a setting based on Mutoh’s values.
Step 5 : Press the [ENTER] key to confirm the selected user setting. The Ultima cutting plotter will load
the requested settings into the active user setting. The active user setting will now have the
settings based on Mutoh’s values.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
3.2.7.3. ‘Add’
To add a new user setting, please follow the instructions below.
Step 1 : Change all settings for the specific cutting job you will perform.
Step 2 : To store all these settings, press the [PRESETS] key.
Step 3 : Use the [UP] or [DOWN] key to select the following display.
Presets
Add
Choose user
Step 4 : Press the [ENTER] key. The Ultima cutting plotter will store all settings in a new user setting.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.