User’s Guide – Ultima cutting plotter
50 AP-75032, Rev 2.2, 20/04/07
3.5.2 Print deformation
This function is a warning. Following message could appear when the printed box on the vinyl or other media
is deformed. This means, not a perfect rectangle.
The Ultima can not guarantee a perfect cut workflow when the box is deformed.
When measuring the four points of the box and the cutter establishes a distortion, the cutter will beep and
shows following message:
EPOS-warning
********************
Much print
distortion
The cutter will cut a little cross in the lower right corner and will continue its workflow after two seconds.
To Next Page
Loading...
