MUTOH Ultima - Bézier Selection; Language Selection

User’s Guide – Ultima cutting plotter
63 AP-75032, Rev 2.2, 20/04/07
4.2.13. Bézier selection
This is the calculation accuracy factor for the incorporated Bézier curve generation. The value can be set
between 1 and 10.
To change the Bézier settings, please follow the instructions mentioned below :
Step 1 : In the general setting select Bézier settings with the [UP] or [DOWN] key.
Step 2 : Press the [ENTER] key to confirm your selection. The actual Bézier setting will now be shown on
the display
Bezier
Actual : 10
New : 10
Bezier step
Step 3 : By pressing the [UP] or [DOWN] key select the requested value. The following message will
appear on the operation panel.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
Step 4 : Press the [ENTER] key to confirm.
4.2.14. Language selection
It is possible to change the user language of your cutter.
To change the language, please follow the instructions mentioned below :
Step 1 : In the general setting select [LANGUAGE] with the UP or DOWN key
Step 2 : Press the [ENTER] key to confirm your selection. The actual LANGUAGE-setting will now be
shown on the display
Language
Actual : ENGLISH
New : ENGLISH
Language
Step 3 : By pressing the [UP] or [DOWN] key select the appropriate language. Five language settings are
available (English, German, French, Spanish and Dutch).
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
Step 4 : Press the [ENTER] key to confirm and go back to the previous menu.