MUTOH Ultima - Copies

User’s Guide – Ultima cutting plotter
61 AP-75032, Rev 2.2, 20/04/07
4.2.11. Copies
In case multiple outputs of a specific design are needed, you can use the copies function. This function will
replot the last set of data, which was sent to the cutting plotter. That is, all data that was sent since the last
INITIALISATION command (“IN”).
To change the copy-value, please follow the instructions mentioned below :
Step 1 : In the general setting select ‘Copies’ by using the [UP] or [DOWN] key.
Step 2 : Press the [ENTER] key to confirm your selection. The display will show the following message.
Copies
Actual : 1
New 1
Times to copy
Step 3 : By using the [UP] or [DOWN] key select ‘YES’’.
Step 4 : Press the [ENTER] key to confirm.
Notes
To cancel the changes of the parameter, press the [CANCEL] key. The display will show the previous
value for the parameter.
When you press the [EXIT] key the changed value will be ignored and you go back to the previous menu.
Notes
When you want to make copies, make sure that the ‘Sheet OFF’ mode is enabled. Otherwise you’ll perform
a multi-cut. The cutter will cut continuously on the same place.
Notes
In case of identical frames without barcode, copying contour cutting tasks can be done via the COPY menu
option as well as from roll and sheet.