MUTOH ValueJet 1608 HS User Manual

User’s Guide ValueJet 1608 HS
Printer menu
AP-75810 - Revision 2.0 105
5
5.4 Panel Setup Menu
5.4.1 Menu 1: Setup
In the table below you will find the complete menu structure and its functions.
Setup item Description
Set 1: MediaType Set up the media type for printing
Set 2: Effect Set up the effect menu
Set 3: Spitting Set up the spitting operation while printing
Set 4: Side Margin Set up the right and left margin when printing
Set 5: Media initial
Set up whether the media width and edge are detected when
initializing the media.
Set 6: Media Width/
MediaWidth Check
Specifies the media width between the loading mark and the left
end if not performing a media detection during initialization.
Displays the detected media width if performing a media
detection during initialization.
Set 7: Take-up Set to on when using a take-up system
Set 9: Origin Set the start position of the printing data
Set 10: Prev. Stick Set up to prevent media from sticking when printing.
Set 11: Media heat Perform the setting for the heating operation of the air heater.
Set 12: Head travel Set up the distance to move the print head while printing.
Set 13: Multistrike Set up the multi strike per swath.
Set 14: strike wait Set up the waiting time while overwrite printing
Set 15: Slant Check Set up the slanting detecting between two consecutive print jobs.
Set 16: Auto Cleaning Set up the auto cleaning time while printing.
Set 17: Ink Status Displays the remaining ink level of the ink cassette.
Set 18: Roll Length Set up the roll media length.
Set 19: Longstore Perform a longstore
Set 20: CR Maintance Unlocks the carriage from the home position to clean the wiper.
Set 21: Initialization Restores the print parameter values to the factory defaults.
Set 22: Life Times Display the operational life time of each part
Set 23: IP Address Set the IP address of the printer
Set 24: Subnet Mask Set the subnet mask of the printer
Set 25: Gateway Set the Gateway.
Set 26: BtmInterlace Sets the BtmInterlace function.
Set 27: On cleaning Perform a cleaning cycle at power up.
Set 28: Temporary
The settings of “OFF” or “ALL OFF” are displayed in the setup
menu temporary.
---
CANCEL: shifts to the previous hierarchy.
Downloaded From ManualsPrinter.com Manuals

MUTOH ValueJet 1608 HS Specifications

General

Brand	MUTOH
Model	ValueJet 1608 HS
Category	Printer
Language	English