MUTOH ValueJet 1608 HS - The Media Is Crumpled During Initialization

User’s Guide ValueJet 1608 HS
AP-75810 - Revision 2.0 165
7
The media is crumpled during initialization
N° Possible cause Remedy Reference
1
Are you using recommended
media?
Use recommended media.
Setting media
type on page40
2
Is the loading position of the
media correct?
Set the media correctly.
Loading roll
media on
page37
3 Is the media loaded at an angle? Set the media straight.
Loading roll
media on
page37
4
Are there any foreign materials
such as paper attached to the
pressurizing roller?
Clean the pressurizing roller.
Cleaning the
inside of the
printer on
page138
5
Is the printer used in an
environment other than specified,
such as near an air conditioner?
Only use the printer in an
environment that is specified for
use.
Installation
manual
6
Are you using folded, torn or
rolled media?
Replace the media.
Notes on
handling media
on page74
7
Is each heater set to the
appropriate temperature?
Set it to the appropriate
temperature.
Heater settings
on page50
8
Is pressure adjustment value set
correctly?
Set an appropriate pressure
value.
Adjusting the
pressure on the
media on
page48
Downloaded From ManualsPrinter.com Manuals