User’s Guide ValueJet 1608 HS
Periodical maintenance
144 AP-75810 - Revision 2.0
Step 6: After completing the cleaning, press Enter.
The cleaning wiper returns to its original position.
The print head returns to its original position.
The printer starts the procedure to power OFF.
The printer automatically powers OFF.
Step 7: After cleaning, leave the cleaning stick in the cleaning fluid to store.
Cleaning the cleaning wiper unit and head cap unit
This sub-section describes how to clean the cleaning wiper and surrounding area.
Step 1: Open maintenance cover on the right side of the printer and remove it.
Note
Replace the cleaning stick every week.
Do not use a cleaning stick that has dried ink on it.
Make sure to cover the plastic cup that has cleaning fluid with a plastic bag to
avoid dust.
Replace the cleaning fluid poured into the plastic cup every week.
N° Description
1
Maintenance cover
Note
• When cleaning the cleaning wiper
Do not touch the cleaning wiper and head cap unit.
Head cleaning may not be performed correctly because of oil from your hands.
Make sure to use a cleaning stick, and dip it in the specialized cleaning fluid, and
then clean around the print head.
Wipe it with a fluid other than cleaning fluid can cause the print head to clog.
Cleaning sticks can be used for about 1 week.
After 1 week, or when you cannot remove ink clumps, replace the cleaning stick.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General