MUTOH ValueJet 1608 HS User Manual

User’s Guide ValueJet 1608 HS
AP-75810 - Revision 2.0 161
7
7.1 Malfunctions and failures
This section describes undisplayed malfunctions and failures of the printer, possible causes
and countermeasures.
7.1.1 Problems in installation and introduction
Cannot perform the initial ink charge
Ink does not come out after ink replenishment
N° Possible cause Remedy Reference
1
Is the front cover open or media
loading lever raised?
Close the front cover, or lower the
media loading lever.
Setting media
type on page40
2 Is the maintenance cover open? Close the maintenance cover.
Cleaning the
cleaning wiper
and around the
print head on
page143
3
Are all S/C cards and ink bags
fully inserted?
Fully insert all S/C cards and ink
bags.
Replacing the
ink bags on
page61
4
Is the waste fluid sensor cable
inserted?
Fully insert the waste fluid sensor
cable to the waste fluid sensor
connector.
Installation
manual
N° Possible cause Remedy Reference
1 Is the ink bag cold and frozen?
Leave the ink bag at room
temperature for at least 3 hours,
and perform cleaning several
times.
2
Is the power turned OFF during
ink replenishment?
Power ON again and continue ink
replenishment.
Replacing the
ink bags on
page61
3
Occasionally, normal printing
cannot be performed after ink
replenishment.
Perform little charge.
Set 27: Startup
clean menu on
page131
Downloaded From ManualsPrinter.com Manuals

MUTOH ValueJet 1608 HS Specifications

General

Brand	MUTOH
Model	ValueJet 1608 HS
Category	Printer
Language	English