MUTOH ValueJet 1608 HS - Settings that Can be Changed or Confirmed While Printing

User’s Guide ValueJet 1608 HS
Printer menu
AP-75810 - Revision 2.0 97
5
Settings that can be changed or confirmed while printing
Note
 The Print start menu is displayed only when the printer is warming up.
 When you change a setting during operation, be sure to select “Backup” to
save the setting that you changed.
 If the printer returns to Normal without “Backup” being selected, the changed
setting is not saved.
Setup item Setting Description
Print Start —
Enter: If the heater temperature does
not reach the set value during
warming-up, printing starts.
Temperature
Pre
Check the current Pre Heater
temperature.
Platen
Check the current Platen Heater
temperature.
After Check the current Drier temperature.
Pre Heater Off / 30 °C to 50 °C Change the Pre Heater temperature.
Platen Heater Off / 30 °C to 50 °C Change the Platen Heater temperature.
After Heater Off / 30 °C to 50 °C Change the Drier temperature.
Air heater Off / 130°C to 190°C Change the air heater
PF Adjust
–20 pulse to 0 to 20
pulse
Change the feed adjustment value.
Backup —
ENTER: Save the changed setting.
—
CANCEL: The printer returns to Normal.
Downloaded From ManualsPrinter.com Manuals