MUTOH ValueJet 1608 HS User Manual

User’s Guide ValueJet 1608 HS
168 AP-75810 - Revision 2.0
The printing position is incorrect
(some parts of the media cannot be printed on)
Printing is blurred
N° Possible cause Remedy Reference
1
Is the loading position of the
media correct?
Load the media correctly.
Loading roll
media on
page37
2
Did you set up the origin and print
position?
Cancel or reset the settings of the
origin and print position.
Panel Setup
Menu on
page105
3
Is pressure adjustment value set
correctly?
Set an appropriate pressure
value.
Adjusting the
pressure on the
media on
page48
N° Possible cause Remedy Reference
1
Are you using recommended
media?
Use recommended media.
Setting media
type on page40
2
Are you using thick or thin
media?
Use recommended media.
Setting media
type on page40
3
Is the media printed on the
printing surface?
Confirm the printing surface of
the media and set it correctly.
Loading roll
media on
page37
4 Did you perform Alignment? Perform Alignment.
Set the correct
distance adjust
(Step) on
page81
5
Did you perform Media feed
compensation?
Perform Media feed
compensation.
Set the correct
distance adjust
(Step) on
page81
6
Is each heater set to the
appropriate temperature?
Set it to the appropriate
temperature.
Heater settings
on page50
7
Is pressure adjustment value set
correctly?
Set an appropriate pressure
value.
Adjusting the
pressure on the
media on
page48
Downloaded From ManualsPrinter.com Manuals

MUTOH ValueJet 1608 HS Specifications

General

Brand	MUTOH
Model	ValueJet 1608 HS
Category	Printer
Language	English