MUTOH ValueJet 1608 HS User Manual

User’s Guide ValueJet 1608 HS
164 AP-75810 - Revision 2.0
7.1.3 Media-related troubleshooting
The media slips or is torn during initialization
Note
 If the media is jammed or torn, refer to The media is jammed on page178
N° Possible cause Remedy Reference
1
Are you using recommended
media?
Use recommended media.
Setting media
type on page40
2
Is the loading position of the
media correct?
Load the media correctly.
Loading media
on page32
3 Is the roll media loaded correctly? Load the roll media correctly.
Loading media
on page32
4
Are there any foreign materials
such as paper attached to the
pressurizing roller?
Clean the pressurizing roller.
Cleaning the
inside of the
printer on
page138
5
Is the printer used in an
environment other than the one
specified, such as in direct
sunlight?
Only use the printer in an
environment that is specified for
use.
Installation
manual
6
Are you using folded, torn or
rolled media?
Replace the media.
Notes on
handling media
on page74
7 Does the media bend?
Use recommended media.
When using media other than the
dedicated one, set the Vacuum
Fan menu.
Setting media
type on page40
8
Is the media thickness value
correct?
Re-set so that media thickness
detection will be conducted, and
then re-set the media.
Set 5: Media
initial menu on
page118
Downloaded From ManualsPrinter.com Manuals

MUTOH ValueJet 1608 HS Specifications

General

Brand	MUTOH
Model	ValueJet 1608 HS
Category	Printer
Language	English