MUTOH ValueJet 1608 HS - Pre-Heater Temperature Setting

User’s Guide ValueJet 1608 HS
Basics
AP-75810 - Revision 2.0 51
3
Pre-heater temperature setting
Set the pre-heater temperature following the procedure below.
Step 1: Press Menu.
 The operation panel displays “Menu 1: Setup>”.
Step 2: Press >.
 The operation panel displays “Set1: MediaType”.
Step 3: Press Enter.
 The operation panel displays “Media: Type 1".
Step 4: Press the + or – to select the media type for using.
Downloaded From ManualsPrinter.com Manuals