MUTOH ValueJet 1608 HS User Manual

User’s Guide ValueJet 1608 HS
176 AP-75810 - Revision 2.0
7.2.3 Data error display and solutions
This section describes data error messages and remedies.
A data error appears if there is a failure in data communication between your PC and the
printer.
If a data error occurs, the following error message appears on the operation panel and
operation stops.
When the cause of the error is solved, the printer starts operating again.
7.2.4 Command error display and remedies
This section describes command errors and remedies.
A command error is displayed if a certain failure occurs during analysis of the command data
sent from your PC to the printer.
If a command error occurs, the following error message appears on the operation panel and
operation stops.
When the error is solved, the printer starts operating again.
N° Display Description Remedy Reference
1 I** Error [ ]
An error occurred
when receiving data.
Check the
communication
requirements
between the printer
and your PC.
Menu setup on
the operation
panel on
page99
Note
 "***" in the error message is the code no. that indicates what type of error
occurred.
N° Display Description Remedy Reference
1 MH** Error [ ]
An invalid command
has been sent from
the computer.
Check that the
settings on your PC
and the printer are
the same.
Menu setup on
the operation
panel on
page99
Note
 "***" in the error message is the code no. that indicates what type of error
occurred.
 The command code representing the error occurred may be indicated in [ ].
 For the settings on your PC side, refer to the Operating Manual attached with
your PC.
Downloaded From ManualsPrinter.com Manuals

MUTOH ValueJet 1608 HS Specifications

General

Brand	MUTOH
Model	ValueJet 1608 HS
Category	Printer
Language	English