User’s Guide ValueJet 1608 HS
Safety instructions
14 AP-75810 - Revision 2.0
To prevent back pains and other injuries, always work with at least 4 people to unpack or
move the machine.
Stop using your machine if a liquid has been spilled into it. This may cause electrical shock
or fire. Switch the machine off as soon as possible, unplug the power cord, and contact
your local Mutoh dealer.
Be sure to power OFF the machine and unplug the power cable from the outlet before
cleaning the machine. Use a damp cloth to clean the machine. Do not use thinner,
benzene, alcohol or other active agents. Doing so may result in damage or paint peeling
from the casing.
Do not bend or pull the waste fluid tube. Doing so may cause waste fluid to leak out and
malfunction of the product.
Do not tilt the machine, place it against a wall or turn it upside down. Doing so may cause
ink to leak inside the machine. Movement after transport is also not covered by the
warranty.
When cutting roll media, be careful of the following. Incorrect handling can result in injury
to the hands and fingers from the razor blade.
When holding the media, do not place fingers over the media cut groove.
Move the razor blade slowly along the media cutting groove.
Do NOT transport the machine to another room without contacting your local Authorized
Mutoh Dealer.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General