VJ-1628X OPERATION MANUAL Handling the printer
4.2 Media 169
d. After the confirmation adjustment printing, cut the media.
4.4.3 Cutting media
6. Measure the distance between the two pluses in the confirmation adjustment print using a ruler.
Then, confirm that the distance matches the feeding length when printing.
a. If the distance does not match the feeding length, follow the procedure from Step 1 to Step 5 and
readjust.
b. If the distance matches the feeding length, proceed to step 7.
7. Performs Micro Adjustment Print.
a. Display the Dist.Adj menu on Operation panel in the same way as in Step 1.
b. Press the [+] key or [–] key on Operation panel to select “PF4: Micro Print”.
c. Press the [Enter] key on Operation panel.
• “Warming up Skip ->E” is displayed on Operation panel.
• While “Warming Up” is displayed, do not touch Platen and Media guide. They
become very hot and you could burn yourself.
• You can start printing during warming up.
4.4.7 Starting printing during warming up
• “Printing” is displayed on Operation panel.
(The printer starts printing after warming up is complete.)
• Starts micro adjustment printing.
To Next Page
Loading...
Need help?
General