MUTOH ValueJet VJ1324X - 3.7.3 Connecting a network interface cable

VJ-1324X OPERATION MANUAL Before using
3.7 Connecting the printer to PC 105
3.7.3 Connecting a network interface cable
This section explains how to connect a network interface cable.
Follow the procedure below to connect this printer to your PC.
1. Turn OFF both the printer and PC.
2. Insert the network interface cable into the network interface connector located on the back of the
printer.
3. Fix the network interface cable to the cable clamp.
4. Connect the other connector of the network interface cable to your PC.
TIP
•About connecting to your PC, refer to the operation manual included with the PC.
•For network setting on the side of the printer, refer to “
4.3.2 Panel setup menu overview”.
No. Name
1 Network interface cable
2 Network interface cable connector
No. Name
1 Network interface cable
2 Cable clamp
1
2