Panel setup menu VJ-1324X OPERATION MANUAL
142 5.1 Setup menu
5.1.1.1.3 Adjust Print menu
Sets up when adjusting the printer for the optimum quality of image print.
This setting is different for each user type setting.
• This printer was adjusted at the factory shipment so that it obtains the optimum printing quality.
Adjust the quality if the print quality changes after the installation environment or the media is
changed.
• After performing Standard adjust print and changing the user type setting, make sure to perform
Adjust print.
• When performing Custom adjust print, the print modes are adjusted all at once. Therefore, you do
not need to perform print adjustment even when the user type setting has been newly set or changed.
• When using RIP software, etc, and setting the resolution which is different from the setting in the
user type setting, make sure to perform adjustment for all print modes by Custom Adjust Print.
Media thickness menu
• The settings here are the same as 5.1.1.1.9 Media thickness menu.
Setup item Setting Description
Adjust Print Media Thickness Shifts to the menu where you can enter the thickness of the
media you are using.
5.1.1.1.9 Media thickness menu
—
• [Cancel] key: shifts to the previous menu.
5.1.1.1 User Type menu
Setup item Setting Description
Media Thickness
80
µm to <170µm> to
1300
µm
Enter the thickness of the media you are using.
• [Enter] key: saves the setting and shifts to the sub menu.
Standard Adjust Print Menu
Custom Adjust Print Menu
—
• [Cancel] key: shifts to the previous menu.
5.1.1.1 User Type menu