VJ-1324X OPERATION MANUAL Panel setup menu
5.1 Setup menu 173
5.1.17.2 Print Stop menu
You can set whether or not to display “Roll Remain Error” and pause printing when the length of the roll
media that is counted inside the printer becomes 0.
• Normally you can set this as “Off” as the rear sensor detects when the roll paper is finished.
• If you are using the roll media that does not come off the paper core easily when it is finished,
printing may not be paused when the roll media is finished, if the print pause menu is set to “Off”.
If this happens, set this to “On”.
• When “Roll Remain Error” or “Roll Near End” has occurred while the Print Pause menu is set to
“On”, if you lower the media set lever after replacing to the new roll media, the Roll Media Length
Setting menu is displayed. Enter the length of the roll media you have set.
Setup item Setting Description
Print Stop <Off> The roll media remaining count is not used to judge for
pausing printing. Printing pauses when the rear sensor
responds.
• [Enter] key: saves the setting and shifts to the sub menu.
5.1.17 Roll Length menu
On Even when the rear sensor does not respond, printing pauses
when the roll media remaining count becomes 0.
• [Enter] key: saves the setting and shifts to the sub menu.
5.1.17.3 Near End menu
—
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.17 Roll Length menu
To Next Page
Loading...
