MUTOH ValueJet VJ1324X - 5.1.9 Prev. Stick menu; 5.1.10 StandbyHeating menu

VJ-1324X OPERATION MANUAL Panel setup menu
5.1 Setup menu 163
5.1.9 Prev. Stick menu
Sets up to prevent media from sticking when printing starts.
NOTE
• When the Output Mode menu is set to “Take-up”, the setting for the Prev. Stick menu is disabled.
5.1.6 Output Mode menu
5.1.10 StandbyHeating menu
Sets the time to preheat the heater while the printer is n standby mode.
Setup item Setting Description
Prev. Stick <Off> The stick-prevent operation is not performed.
On The stick-prevent operation is performed.
Feed the media back and forth to prevent from sticking.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Standby Heating 10 minutes - <60 minutes> Sets the time to pre-heat the heater.
When the preset time has passed, each heater turns Off.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.1.1 User Type menu