VJ-1324X OPERATION MANUAL Before using
3.3 Installing ink cartridges 51
• Do not perform the following operations during ink charging. If charging is
interrupted, ink will be lost when charging is resumed.
• Do not turn OFF the power of the printer.
• Do not unplug the power cable of the printer.
• Do not open the front cover.
• Do not open the maintenance cover.
• Do not raise the media loading lever.
• After the ink charging is complete, “Media End” is displayed on the operation panel.
• If the printer perform the nozzle check printing immediately after initial ink charging is complete,
the following results may occur.
• Printed lines become blurred.
• The data is partially not printed.
In such cases, follow “
6.2.3 Head cleaning” and perform “Little Charge”. Then, check the
printing result.
If there is no improvement in the print result even after performing “Little Charge”, leave the printer
unused for an hour or more. Then, perform “Little Charge” again and check the print result.
If there is still no improvement, contact your local MUTOH dealer.
3.3.3 When using the high capacity pack adapter for the printer
whose ink is charged for the first time
The air inside the high capacity pack adapter goes into the printer ink tube and may cause nozzle
clogging. Make sure to perform initial ink charge from the Cleaning menu in the following case.
• When using the high capacity pack adapter for the printer whose ink is charged for the first time
• When replacing the high capacity pack adapter’s adapter itself with a new one
5.3 Cleaning menu
To Next Page
Loading...
Need help?
General