Panel setup menu VJ-1324X OPERATION MANUAL
174 5.1 Setup menu
5.1.17.3 Near End menu
You can display “Roll Near End: *m” (* is replaced with a number between 1 and 10) before the length
of the roll media that is counted inside the printer becomes 0.
5.1.18 Longstore menu
Wash the print head with the cleaning fluid.
• Make sure to use the dedicated cleaning fluid (Model number: VJ-MSINK3-CL220/VJ-MSINK3-
CL1000).
Setup item Setting Description
Near end <Off> “Near end” is not displayed.
Remain: 10 m to 1 m “Near end” is displayed when the remaining count for the roll
media becomes the length you selected.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
5.1.17 Roll Length menu
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.17.2 Print Stop menu
Setup item Setting Description
Longstore Start Wash the print head with the cleaning fluid.
• [Enter] key:
Performs the head washing operation.
The following content is displayed on the operation panel.
Remove Cartridges Remove the ink cartridge, and install the cleaning cartridge.
6.1.1 Replacing ink cartridges
—
• [Cancel] key: shifts to the previous menu without Head
washing.
5.1 Setup menu
To Next Page
Loading...
Need help?
General