Before using VJ-1324X OPERATION MANUAL
94 3.6 Adjust Print
3.6.2.2.2 Rough Pattern A to F
Print one adjustment pattern from A to F and register the set value.
The following describes how to adjust pattern A only.
1. Display the Custom Adjust Print menu on Operation panel in the same way as Step 2 of
3.6.2.1 Custom Confirmation Pattern.
2. Press the [+] key or [-] key on Operation panel to select “Adj.3: RoughPattern A”.
3. Press the [Enter] key on Operation panel.
• “Warming Up Skip ->E” is displayed on Operation panel.
• While “Warming Up” is displayed, do not touch Platen and Media guide.
They become very hot and you could burn yourself.
• You can start printing during warming up.
4.4.7 Start Printing during Warm up