VJ-1324X OPERATION MANUAL Panel setup menu
5.1 Setup menu 179
5.1.26 Start Feed Menu
If you set the start feed beforehand, you can change the margins between the print results.
• When the media roll surface becomes wavy due to the influence of the pre-heater, set a wider
margin before printer starts to stop the degradation of print quality.
• When using the take-up device and setting the “Start Feed” as less than 0, set the “Page Gap” as
“Narrow”. If it is set as “Normal”, the settings for “Start Feed” is not applied correctly.
5.1.6.2 Page Gap menu
5.1.27 Heater Control menu
Paper cocklings may occur during printing when heated. This can be minimized by selecting an
appropriate setting as follows.
Setup Item Description Setup Item
Start Feed -10 mm to <0 mm> to
500 mm
• When the value is bigger than 0: the margins are bigger than
when it is set to “0”.
• When the value is 0: the margin between print results does
not change.
• When the value is smaller than 0: the margins are smaller
than when it is set to “0”.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup item Setting Description
Heater Ctrl <Normal> Default setting.
Select Normal if paper cocklings do not occur.
Fixer Select Fixer to reduce waiting times before printing and paper
cocklings.
Dryer Select Dryer to keep the drying performance after printing
when using a Heavy-Duty Take-up Unit and minimize paper
cocklings.
—
• [Enter] key: saves the setting and shifts to the selected
menu.
• [Cancel] key: cancels the setting value and shifts to the
previous menu.
5.1 Setup menu
To Next Page
Loading...
Need help?
General