MUTOH ValueJet VJ1324X - 5.1.6 Output Mode menu

Panel setup menu VJ-1324X OPERATION MANUAL
158 5.1 Setup menu
(2) MediaWidth menu
5.1.6 Output Mode menu
Sets the media operation after printing.
NOTE
• When the take-up unit is not installed, do not set Output mode to “Take-up”.
By doing so, the product will be unable to function properly.
• When the Output Mode menu is set to “Take-up”, the setting for the Prev. Stick menu is disabled.
5.1.9 Prev. Stick menu
Setup item Setting Description
MediaWidth **** mm Display the media width that is detected while initializing.
—
• [Cancel] key: shifts to the previous menu.
5.1 Setup menu
Setup item Setting Description
Output mode <Off> Set when not cutting the media automatically after printing.
(Set it to Off even when cutting the media manually.)
• [Enter] key: saves the setting and shifts to the sub menu.
5.1.6.1 Ink Drying Time Menu
Take-up Set when using the take-up unit.
(The media will not be cut after printing.)
• [Enter] key: saves the setting and shifts to the sub menu.
5.1.6.2 Page Gap menu
Auto Cut Set when cutting the media automatically.
• [Enter] key: saves the setting and shifts to the sub menu.
5.1.6.1 Ink Drying Time Menu
—
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu