Panel setup menu VJ-1324X OPERATION MANUAL
160 5.1 Setup menu
5.1.6.2 Page Gap menu
If you set the media ejection mode to “Take-up”, the menu shifts to the Page Gap menu.
In the Page Gap menu, you can change the margins between the print results.
5.1.7 Method of Cut menu
Sets the media cutting operation after printing.
• When the the media detection is set to “Off”, the media cannot be cut automatically.
• Some media may not be cut (cannot be cut at all or cannot be cut finely). In such a case, set the
“Output Mode menu” to “Off” and cut the media manually.
5.1.6 Output Mode menu
4.4.4 Cutting media manually
• The cutting direction is different depending on the firmware version.
Setup item Setting Description
Page Gap <Normal> Does not change the margin between print results.
Narrow The margin between print results becomes narrower than
when it is set to “Normal”.
—
• [Enter] key: saves the setting and shifts to the sub menu.
5.1.6.1 Ink Drying Time Menu
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.6 Output Mode menu
Setup item Setting Description
Method of Cut SingleCut-2 steps Cuts at a shorter process than SingleCut-3 steps method.
Suitable for media with a narrow width.
<SingleCut-3 steps> Normal cutting method.
DoubleCut-2 steps Set when the media is not cut with SingleCut-2 steps method.
Suitable for media with a narrow width.
DoubleCut-3 steps Set when the media is not cut with SingleCut-3 steps method.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
5.1.7.1 Cut Pressure menu
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
To Next Page
Loading...
Need help?
General