Maintenance VJ-1324X OPERATION MANUAL
220 6.2 Cleaning the printer
• The printer enters Normal.
• Cleaning the cleaning wiper is complete.
6.2.5 Cleaning around the print head
This section describes how to clean around the print head.
(1) Time for cleaning
When foreign substances such as dust or ink clump that can cause missing dots or ink leakage is attached
around the print head
(2) Cleaning procedures
Follow the procedure below to clean around the print head.
• Before cleaning around the print head, read this procedure thoroughly to fully understand it, and
clean promptly and correctly.
• While cleaning around the print head, the print head cap is removed, therefore cleaning must be
done before the print head dries.
This operation should be done within 15 minutes.
If the operation lasts over 15 minutes, follow the Steps 8 and 9 to stop the operation and perform
head cleaning, then resume cleaning.
6.2.3 Head cleaning
• Use the cleaning stick to clean around the print head.
For details of the cleaning stick, refer to “
8.3 Options/Supply list”.
1. If the printer is turned ON, make sure the following.
• Printing or other operations are not in progress.
• The operation panel display is Normal.
To Next Page
Loading...
