Maintenance VJ-1324X OPERATION MANUAL
210 6.2 Cleaning the printer
6.2 Cleaning the printer
Periodic (every month) cleaning is necessary to use the printer in good condition.
• Do not insert or drop metal or flammable objects into the printer through openings
such as a vent.
It could lead to an electric shock or fire.
• If foreign substances or liquids such as water entered the printer, do not use the
printer as it is.
It could lead to an electric shock or fire.
Immediately turn OFF the power switch, disconnect the power plug from the electric
socket, and contact your local MUTOH dealer.
• When cleaning the areas other than the wiper, make sure to turn OFF the power and
unplug the power cable.
• Do not use volatile solvents such as thinner, benzene, or alcohol.
These solvents could cause damage to the paint.
• Be careful that no moisture enters the printer.
There is a possibility that the electric circuit inside the printer is short circuited.
• Do not open covers attached using screws under any circumstances.
This may cause an electric shock or a malfunction.
This section describes how to clean each part of the printer.
To Next Page
Loading...
