VJ-1324X OPERATION MANUAL Panel setup menu
5.1 Setup menu 135
Slant Check Sets up slanting detection during media loading.
• [Enter] key: shifts to the sub menu.
5.1.14 Slant Check menu
Auto Cleaning Sets up the time for auto cleaning during standby, before printing, and during printing.
• [Enter] key: shifts to the sub menu.
5.1.15 Auto Cleaning menu
Ink Status Displays the various information (ink status) about ink cartridges that are installed in the slots
and information about Smart/C.
• [Enter] key: shifts to the sub menu.
5.1.16 Ink Status menu
Roll Length Sets up the roll media length.
• [Enter] key: shifts to the sub menu.
5.1.17 Roll Length menu
Longstore Wash the print head with the cleaning fluid.
• [Enter] key: shifts to the sub menu.
5.1.18 Longstore menu
CR Maintenance Performs maintenance.
• [Enter] key: shifts to the sub menu.
5.1.19 CR Maintenance menu
Initialization Returns the settings of the printer to default.
• [Enter] key: shifts to the sub menu.
5.1.20 Initialization menu
Life Times Displays the operational life time of each part.
• [Enter] key: shifts to the sub menu.
5.1.21 Life Times menu
IP Address Sets the IP address of the printer.
• [Enter] key: shifts to the sub menu.
5.1.22 IP Address menu
Subnet Mask Sets the subnet mask of the printer.
• [Enter] key: shifts to the sub menu.
5.1.23 Subnet Mask menu
Gateway Sets the gateway.
• [Enter] key: shifts to the sub menu.
5.1.24 Gateway menu
Header dump Set whether or not to print the dump data of print data.
• [Enter] key: shifts to the sub menu.
5.1.25 Header Dump menu
Start Feed Rewinds or feeds the media the amount specified by the set value.
• [Enter] key: Moves to the sub menu.
5.1.26 Start Feed Menu
Heater Control This function is to specify the heater control modes depending on the usages.
• [Enter] key: shifts to the sub menu.
5.1.27 Heater Control menu
Setup item Description
To Next Page
Loading...
Need help?
General