VJ-1324X OPERATION MANUAL Panel setup menu
5.1 Setup menu 145
(2) Init.Adj.Change menu
Sets up Initial Adjust Change.
(3) Confirm Print menu
Performs Confirm Print.
(4) Micro Print menu
Performs Micro Adjustment Print.
Setup item Setting Description
Init. The set value ±50.0mm in
“Feed length” of Initial adjust
print
Sets up Initial Adjust Change.
e.g) When the set value in “Feed length*” of Initial adjust
print is set to 250mm, the adjustment range in this menu is
200mm to 300mm.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.1.1.4 Dist.Adj menu
Setup item Setting Description
FeedLength 100mm to <250mm> to
500mm
Changes the length (feed length) of the media feed direction
for Confirm Print.
• [Enter] key:
Determines the setting.
“Printing” is displayed on the operation panel and Initial
Print starts.
After printing, the printer enters Normal.
—
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1.1.1.4 Dist.Adj menu
Setup item Setting Description
Micro Print -5.00% to <0.00%> to 5.00%
(After printing)
• Prints a micro adjustment pattern based on the currently set
micro adjustment value with each of the following values
applied to it.
±0.10%、±0.20%、±0.50%、±0.80%、±1.20%
• After printing, enter a micro adjustment value in the
following range:
-5.00% ～ <0.00%> ～ 5.00%
—
• [Cancel] key: shifts to the previous menu.
Stops printing and returns to the previous menu if printing
is in progress.
5.1 Setup menu
To Next Page
Loading...
Need help?
General