Electrical system
CONNECTORS
• When a connector is connected, check that it clicks
into position.
• Check the connector for corrosion, dirt or a broken
cover.
COUPLINGS
• Block couplings – ensure that the block is released
before disconnecting it to push it completely home
when connecting it.
• When disconnecting a coupling, ensure that the
body of the coupling is gripped and do not pull it
apart by the leads.
• Check that the terminals of the couplings are not
slack or bent.
• Check that the terminals are not corroded or dirty.
FUSES
• When a fuse burns out, always investigate why the
fuse has burnt out. Find the cause, repair and then
substitute the fuse.
• Do not utilise a fuse of a different capacity from the
original one.
• Do not utilise wire or any other substitute for the
fuse.
- 3-
E
CLICK
CLICK
To Next Page
Loading...
