HIGH BEAM HEADLIGHT
In the event that the driving beam does not work, check
the conditions of the following fuse:
- MY10 -> MY12: Fuse 2
- MY13: Fuse 6
- 44 -
Electrical system
E
LOW BEAM HEADLIGHT
MY10 -> MY12:
In the event that the dipping beam does not work,
check the conditions of fuse 3 on the fuse box. If this
fuse is ok, check the conditions of the relay placed on
the left side of the motorcycle, with the label "B".
If this is also ok, check continuity of the R/W cable
which goes from relay "B" to the engine control unit at
terminal 31.
F4 MY10 -> MY12
F4 MY13
F4 MY10 -> MY12
F4 MY13
MY13:
In the event that the dipping beam does not work,
check the conditions of fuse 2 on the fuse box. If this
fuse is ok, check the conditions of the relay placed on
the left side of the motorcycle, with the label "B".