Brakes
- 31 -
H
After having carried out a check on all components and
substituted those used, damaged or defective proceed
with the assembly by following the procedure in
reverse order of removal.
Substitute the gaskets of the pump/caliper
hoses.
Tighten the fixings to the prescribed torque pressure.
Torque pressure pump union: 16÷18 N·m
Torque pressure brake pump/support: 8÷10
N·m
Conclude the operations by filling the system with
brake fluid and successively bleeding the system (see
page 27).
NOTE
REAR BRAKE DISC REMOVAL
Before proceeding with the removal of the rear brake
disc, it is necessary to carry out certain operations
described previously in this chapter:
Remove the rear wheel.
Remove the rear brake disc from its support.
Remove the four nuts fastening the disc to the flange.
Remove the four nuts previously freed by extracting
them from the rear part of the motorcycle and rotating
the disc to facilitate the removal of the nuts.
REAR BRAKE DISC
Check the thickness of the rear brake disc.
Substitute the disc if the measurements are less than
the minimum value allowed. Effectuate the substitution
as hereby described.
- Minimum thickness allowed: 5,7 mm
16÷18 N•m
8÷10 N•m
To Next Page
Loading...
