Electrical system
- 47 -
E
COOLING FAN SYSTEM
If there is a fault in the functioning of the cooling fan,
proceed with the following check:
• Check the condition of the following fuse:
- MY10 -> MY12: Fuse 5
- MY13: Fuse 7
• If the fuse is in good condition, check the cooling fan
relay mounted on the left side of the motorcycle
marked with the letter “F”.
If the relay is in good condition but is not energised
aboard the vehicle, disconnect the connector on the
temperature sensor. Make a bridge between the two
contacts as shown in the figure and check the conti-
nuity of the system.
If this condition is also met, the problem lies with the
temperature sensor.
Check the continuity of the temperature sensor.
HORN
A fault in the horn system should be checked at various
points:
• Check the condition of fuse 1 in the fuse box.
• If the fuse is in good condition, disconnect the con-
nector of the left control and check the continuity
between contact 3-4 of the control with the horn but-
ton pressed as in the following page under
“Switches”.
• Check the continuity of the winding of the horn.
3
4
To Next Page
Loading...
