Electrical system
- 29 -
E
STARTER MOTOR ASSEMBLY
Assemble the starter motor in the reverse order of
removal. Pay attention to the following points:
Substitute the O-ring with a new one to avoid
oil leakage and the ingress of humidity.
• Apply grease to the oil seal lip.
• Apply a small quantity of MOLYKOTE to the rotor
shaft.
• Apply a small quantity of LOCTITE 243 to the bolts
of the starter motor.
F4 MY10 -> MY12
F4 MY13
STARTER RELAY CHECK
• Remove the seat as described in chapter C
Superstructures.
• Disconnect the relay from the support plate.
To Next Page
Loading...
