- 24 -
Maintenance
B
Maintenance
Check again the timing of the engine, ensuring that the
incision stamped on the timing wheel is aligned with
the “tooth” on the engine casing.
Continue with the measuring of the play of the follow-
ing valves:
Cylinders 3 and 4 – intake valves (n° 5, 6, 7, 8).
Cylinders 2 and 4 – exhaust valves (n° 9, 10, 13, 14).
Make a note of the measured values ensuring that they
are scrupulously written in the correct order of the pre-
viously illustrated table.
To Next Page
Loading...
