MV Agusta F4 S - Page 400

- 54 -
Frame
G
Disconnect the coil cable connectors and remove them
as shown in the figure.
Disconnect the two exhaust valve control cables from
the actuator and remove them from the lower right part.
- Only for F4 MY10 -> MY12:
Remove the two control unit fixing screws, sliding them
toward the rear part and resting them on the engine.
G_Telaio_GB_Rev.2_G_Telaio_GB_Rev.2.qxd 23/05/13 15:03 Pagina 54