Cooling system
- 19 -
L
THERMOSTAT ASSEMBLY
Insert the O-ring (1) in its appropriate seat on the cover
of the thermostat.
Check the condition of the O-ring previously utilised.
If the O-ring is not in good condition, substi-
tute it with a new one.
Apply a thin layer of silicone grease.
Recommended grease: Silicone Grease.
Apply grease on the outer flange of the thermostatic
valve on the inlet side of the engine.
Insert the thermostatic valve in its housing on the engi-
ne.
During thermostatic valve assembly, ensure that the
notch (2) present on the outer flange of the valve is
positioned near the machining (3) on the engine.
1
1
2
3
To Next Page
Loading...
