- 6-
Diagnostic
O
Swingarm bearings damaged Replace
Swingarm rocker bearings damaged Replace
Shock absorber joints damaged Replace
Suspension linkage joints damaged Repair
Swingarm pin bent Replace
BRAKES
Brake lever and pedal soft (“spongy”) Air bubbles in hydraulic circuit Bleed
Leaks in hydraulic circuit Repair
Caliper seals damaged Replace
Pump seals damaged Replace
Caliper pistons do not slide freely Check
Brake fluid level low Top up
Brake discs distorted Replace
Brake lever or pedal stiff Brake lever or pedal bent Replace
Braking action insufficient Disks dirty Clean
Air bubbles in hydraulic circuit Bleed
Leaks in hydraulic circuit Repair
Caliper seals damaged Replace
Pump seals damaged Replace
Caliper pistons do not slide freely Check
Brake fluid level low Top up
Brake discs distorted Replace
Brake pads rub against brake disks Brake pad springs damaged Replace
Brake discs distorted Replace
Caliper pistons do not slide freely Check
Brake fluid level too high Adjust
Brake pads worn down Replace
EXHAUST SYSTEM
Exhaust noise excessive Exhaust pipe damaged Replace
Exhaust pipe fasteners loose Tighten
Engine performance poor Exhaust pipe damaged Replace
Exhaust pipe fasteners loose Tighten
COOLING SYSTEM
Engine temperature high Coolant level low Top up
Cooling fan faulty Replace
Expansion tank cap faulty Replace
Instrument temperature sensor faulty Replace
Thermostat locked in closed position Replace
Radiator fins bent or obstructed Repair/Clean
Radiator scaly Clean
Water pump damaged Replace
Injection/ignition system faulty Check
Fuel unsuitable Change
Engine cooling circuit faulty Check
Spark plug heat grade unsuitable Replace
Carbon formation in cylinder head/piston Clean
Engine temperature low Thermostat locked in open position Replace
To Next Page
Loading...
