NEC Storage Manager - iSM08181: Specified value is the same as current value(<a> times;minute); iSM08182: Can’t change display refresh rate(<aaa...a>:<bbb...b>)

Chapter 2 Message List
197
iSM08181: Specified value is the same as
current value(<a> times/minute)
[Classification] NOTICE
[Explanation] The specified value is same as current display refresh rate. The command will be
ignored.
a : Specified refresh rate
[Measures] Unnecessary
iSM08182: Can’t change display refresh
rate(<aaa...a>:<bbb...b>)
[Classification] NOTICE
[Explanation] Display refresh rate cannot be changed for the causes shown in aaa...a.
aaa...a : cause
- stop all clients:
Refresh rate cannot be changed because a performance
monitoring screen is displayed.
- reduce threshold monitoring object:
Refresh rate cannot be changed due to excess number of
threshold monitoring object.
bbb...b : Disk array name
[Measures] Take the measures below.
- If the change was failed because a performance monitoring client was being
connected. (stop all clients)
Terminate all performance monitoring clients, then execute the command
again.
- If the change was failed due to excess number of threshold monitoring object.
(reduce threshold monitoring object) Reduce the threshold monitoring
objects from performance monitoring clients, execute the command again.