NEC Storage Manager - iSM10332: command: <aaa...a>, ATgroup(distributor)=<bbbb>h <ccc...c> [<ddd...d>], status=failed(<ee>h;<ff>h;<gg>h); iSM10333: command: <aaa...a>, ATgroup(concentrator)=<bbbb>h <ccc...c> [<ddd...d>], status=failed(ec=<eee...e>)

Chapter 2 Message List
238
iSM10332: command: <aaa...a>,
ATgroup(distributor)=<bbbb>h
<ccc...c> [<ddd...d>],
status=failed(<ee>h/<ff>h/<gg>h)
[Classification] INFO
[Explanation] It indicates that access to the distributor indicated by the distributor number
failed (SCSI protocol failure).
aaa...a : Command name
bbbb : AT-group (distributor) number
ccc...c : Disk array name of AT-group (distributor)
ddd...d : Disk array name of AT-group (concentrator)
ee : Sense key defined according to SCSI specification
ff : Additional sense code defined according to SCSI specification
gg : Additional sense code qualifier defined according to SCSI
specification
[Measures] Check whether the disk array configuration is changed.
iSM10333: command: <aaa...a>,
ATgroup(concentrator)=<bbbb>h
<ccc...c> [<ddd...d>],
status=failed(ec=<eee...e>)
[Classification] INFO
[Explanation] It indicates that access to the concentrator indicated by the concentrator number
failed (failure except for SCSI protocol).
aaa...a : Command name
bbbb : AT-group (concentrator) number
ccc...c : Disk array name of AT-group (concentrator)
ddd...d : Disk array name of AT-group (distributor) (Output if fixed)
eee...e : Error code indicating the type of abnormal state
[Measures] Check whether the disk array configuration is changed.