NEC Storage Manager - iSM03142: Management of control path in diskarray[<a>] failed.file=<bbb...b> command=(<ccc...c>) status=(<dddddddd>) detail=<ee-ffff>; iSM03142: Management of control path in diskarray[<a>] failed. Disk=(disk<bbb> (Port<ccc> Bus<ddd> Target<eee> Lun<fff>)) command=(<ggg...g>) status=(<hhhhhhhh>) detail=<ii-jjjj>

Chapter 2 Message List
45
iSM03142: Management of control path in
diskarray[<a>] failed.file=<bbb...b>
command=(<ccc...c>)
status=(<dddddddd>) detail=<ee-ffff>
[Classification] NOTICE
[Explanation] Failed in the inclusion of the control path.
This message is output on UNIX system.
a : Disk array specification number (1 to 64) in the environment
definition file (agent section)
bbb...b : Special file name
ccc...c : Command Descriptor Block of the issued command
dddddddd : Status Byte
ee-ffff : Detail information (This code is not disorder reason but a value
for maintenance.)
[Measures] Check the disk array state, and remove the failure.
iSM03142: Management of control path in
diskarray[<a>] failed.
Disk=(disk<bbb> (Port<ccc>
Bus<ddd> Target<eee> Lun<fff>))
command=(<ggg...g>)
status=(<hhhhhhhh>) detail=<ii-jjjj>
[Classification] NOTICE
[Explanation] Failed in the inclusion of the control path.
This message is output on Windows system.
a : Disk array specification number (1 to 32) in the environment
definition file (agent section)
diskbbb (Portccc Busddd Targeteee Lunfff): Disk information
ggg...g : Command Descriptor Block of the issued command
hhhhhhhh : Status Byte
ii-jjjj : Detail information (This code is not disorder reason but a value
for maintenance.)
[Measures] Check the disk array state, and remove the failure.