NEC Storage Manager - iSM13592: Target ATgroup is not separated. ATG=<aaa...a> (code=<bbb...b>-<ccc...c>-<ccc...c>-<ccc...c>); iSM13592: Target pair is not separated. (code=<bbb...b>-<ccc...c>-<ccc...c>-<ccc...c>); iSM13593: Target ATgroup is not fault. ATG=<aaa...a> (code=<bbb...b>-<ccc...c>-<ccc...c>-<ccc...c>)

Chapter 2 Message List
386
iSM13592: Target ATgroup is not separated.
ATG=<aaa...a>
(code=<bbb...b>-<ccc...c>-<ccc...c>-<
ccc...c>)
iSM13592: Target pair is not separated.
(code=<bbb...b>-<ccc...c>-<ccc...c>-<
ccc...c>)
[Classification] ERROR
[Explanation] The activity status of the specified pair is not Separate. Or, the specified
AT-group sync state is not separated (Separated) or failure separation (Fault).
aaa...a : AT-group name
bbb...b : Process number
ccc...c : Detailed information (This code is not disorder reason but a
value for maintenance.)
[Measures] If the target is a pair, retry processing when the activity state is separated. If the
target is an AT-group, make the AT-group separated (Separated) or failure
separation (Fault) state, and then re-execute the command.
iSM13593: Target ATgroup is not fault.
ATG=<aaa...a>
(code=<bbb...b>-<ccc...c>-<ccc...c>-<
ccc...c>)
[Classification] ERROR
[Explanation] The specified AT-group sync state is not failure separation (Fault).
aaa...a : AT-group name
bbb...b : Process number
ccc...c : Detailed information (This code is not disorder reason but a
value for maintenance.)
[Measures] Check the state of the AT-group. If you need to interrupt replicate or restore,
forcibly separate it.