NEC Storage Manager - iSM10334: command: <aaa...a>, ATgroup(distributor)=<bbbb>h <ccc...c> [<ddd...d>], status=failed(ec=<eee...e>); iSM10400: copy error:mv=<aaa...a>(<bbbb>h) <ccc...c>, rv=<aaa...a>(<bbbb>h) <ccc...c>, status=<ddd...d>h [,ATgroup=<eee...e>][_ALERT_]

Chapter 2 Message List
239
iSM10334: command: <aaa...a>,
ATgroup(distributor)=<bbbb>h
<ccc...c> [<ddd...d>],
status=failed(ec=<eee...e>)
[Classification] INFO
[Explanation] It indicates that access to the distributor indicated by the distributor number
failed (failure except for SCSI protocol).
aaa...a : Command name
bbbb : AT-group (distributor) number
ccc...c : Disk array name of AT-group (distributor)
ddd...d : Disk array name of AT-group (concentrator)
eee...e : Error code indicating the type of abnormal state
[Measures] Check whether the disk array configuration is changed.
iSM10400: copy error:mv=<aaa...a>(<bbbb>h)
<ccc...c>, rv=<aaa...a>(<bbbb>h)
<ccc...c>, status=<ddd...d>h
[,ATgroup=<eee...e>][_ALERT_]
[Classification] ERROR
[Explanation] It indicates information of volume in which copy fault occurred.
For Windows, this message is target of ESMPRO Manager Report.
aaa...a : Logical disk name
bbbb : Logical disk number
ccc...c : Disk array name
ddd...d : Error code (4: fault separation, 9: abnormal suspend)
eee...e : AT-group (concentrator) name
[Measures] After remove cause of an error, restore the system with reference to description
about replication-specific HW fault in the “Data Replication User’s Manual
(Installation and Operation Guide for Windows)”.