NEC Storage Manager - iSM13540: Illegal volflg type (<aaa...a>); iSM13541: Semi-sync mode is not available to DynamicDataReplication.; iSM13542: Specified targets are not paired.

Chapter 2 Message List
363
iSM13540: Illegal volflg type (<aaa...a>)
[Classification] ERROR
[Explanation] The value specified in the -vol type is invalid.
aaa...a : Specified value
[Measures] Specify a correct value.
iSM13541: Semi-sync mode is not available to
DynamicDataReplication.
[Classification] ERROR
[Explanation] Semi-sync mode cannot be specified for pairs in the same disk array.
[Measures] Change the copy mode and execute it.
iSM13542: Specified targets are not paired.
[Classification] ERROR
[Explanation] Request has been issued to a volume that is not paired or forcibly unpaired. If
RemoteDataReplication is used, the volume information on the paired remote
side cannot be obtained because a fault has occurred in the link path to the disk
array on the remote side or the disk array is in the shutdown or freeze state.
[Measures] Check the state of the volume , and then re-execute the command. If
RemoteDataReplication is used, check the state of the disk array on the remote
side and the state of the link path, and then re-execute the command.