NEC Storage Manager - iSM14448: Set SNMP Trap Transmission: number=<aa>h, Community Name=“<bbb...b>”, SNMP Trap IP Address=<ccc...c>,<ccc...c>,..., status=<ddd...d>

Chapter 2 Message List
506
iSM14448: Set SNMP Trap Transmission :
number=<aa>h, Community
Name=“<bbb...b>”, SNMP Trap IP
Address=<ccc...c>,<ccc...c>,...,
status=<ddd...d>
[Classification] INFO
[Explanation] It indicates that sending destination of SNMP trap was specified. Information
specified here becomes valid after resetting disk array or service processor.
aa : Service processor number
bbb...b : Community name
ccc...c : IP address of SNMP Trap sending destination
ddd...d : Command execution status
good : Normal
failed(xxxx) : Error occurred (xxxx is error description)
---- : Interrupted
[Measures] When an error occurs (status=failed was output), the configuration or setting of
the disk array may be changed. After updating it to the newest information or
restarting state monitoring, check current state and execute again.