NEC Storage Manager - iSM13672: DynamicSnapVolume is not supported. (code=<aaa...a>-<bbb...b>-<bbb...b>-<bbb...b>); iSM13673: Specified attribute (<aaa...a>) does not match the attribute of ATgroup. ATG=<bbb...b> (code=<ccc...c>-<ddd...d>-<ddd...d>-<ddd...d>)

Chapter 2 Message List
420
iSM13672: DynamicSnapVolume is not
supported.
(code=<aaa...a>-<bbb...b>-<bbb...b>-<
bbb...b>)
[Classification] ERROR
[Explanation] DynamicSnapVolume is not supported.
aaa...a : Process number
bbb…b : Detailed information (This code is not disorder reason but a
value for maintenance.)
[Measures] Check the support state of the disk array.
iSM13673: Specified attribute (<aaa...a>) does
not match the attribute of ATgroup.
ATG=<bbb...b>
(code=<ccc...c>-<ddd...d>-<ddd...d>-<
ddd...d>)
[Classification] ERROR
[Explanation] The specified attribute does not match the attribute of the AT-group. To
specify the atomic-break mode or copy mode at restart of replication, the
attribute must match the value specified at start of replication.
aaa...a : Specified attribute value
bbb…b : AT-group name
ccc…c : Process number
ddd…d : Detailed information (This code is not disorder reason but a
value for maintenance.)
[Measures] Specify the same value for the atomic-break mode or copy mode as the value
specified at start of replication. Otherwise, omit specification of the
atomic-break mode or copy mode, and then re-execute the command.